The table below provides specifications for the ATI system probe types.
These probes are for use with an AMIGO instrument with array probe support enabled.
For customers wishing to carry out general thread inspection, other options are available here.
|
|||||||
|
[Picture: Type 377 |
"Thread probes are available to cover a wide range of common drillstring connection sizes" With appropriate adapters fitted, these probes can be used to inspect a variety of pin and box threads - commonly NC38, NC 46, NC50, 4 ½ IF, 6 5 / 8 Reg, 7 5 / 8 Reg and HT40 connectors. Probes for other thread forms are also available. Interchangeable stainless steel scrapers engage in the thread and closely follow the thread profile. The scrapers remove dirt and contaminants from the thread and prevent wear to the thread sensors which are held close to but not in contact with the thread. |
||||||
 Type |
 Description |
 Freq |
 Position Feedback |
 Notes |
 Dimensions |
||
| 377 | Thread Array Probe (4tpi) | 5 kHz | Rotary | Adapters are fitted to either side of the probe that position the thread sensors correctly for the thread size - either Pin or Box. | |||
| 378 | Thread Array Probe (5tpi) | ||||||
| 369 | Thread Array Probe (4tpi) | 50 kHz | Rotary | ||||
| 370 | Thread Array Probe (5tpi) | ||||||
